plastic mould, injection mould

How to design the guided structure of injection mold?

The injection mold has some position  to design the guided structure,How to design the the guided structure ofinjection mold?
 1.guided parts should be distribute next to the injeciotn mold,or near edge position,So as to the injection mold has enough thickness.
2.We should on the basis of the injection mold dimensions and weight to design the  the guided structure.
3.In order to injection products can leave the injction mold easily,We should design the guide pillar in the cavity.
4. the axes of the guide pillar,guide sleeve,guide hole should keep  balance.
Above all should be careful in the design the injection mold,welcome to read the artical about injection mold. 


* Disclaimer: The above information from the network news. Hanking Plastic (Shenzhen) Manufactory CO., LTD does not undertake any responsibility.
* Report complaints: If you found illegal or unhealthy information, click here to report.